Technical Tip of the Week Archives

Technical Tip Of The Week: Are You Using The Right Speeds and Feeds?

There are certain parameters that must be considered, before setting up any job for processing if you are to achieve…

Naturally, when processing material, you will mark the surface of the MDF. Unfortunately, this will eventually cause vacuum bleed. In…

Here are AXYZ we offer a range of pressure feet that offer the perfect solution in many different scenarios. This…

Short of much more expensive solutions, ER collets are one of the best tool holding systems available. However, incorrectly fitting…

For workshops requiring the ultimate level of productivity from their CNC router, look no further than AXYZ. AXYZ offer a…

The ability to cut opposing sides of the material accurately is an increasingly popular customer request. This blog describes how…

Of course the notion of a ‘small’ part depends entirely on the type of job and material you are processing.…

CNC routers need bits. They determine the kind of processing you can do, the resolution of your finished designs, and…

Tool selection is critical when it comes to achieving a desired surface finish, tool life, or cut speed of a…

AXYZ CNC routers are built to be accurate and reliable. We use the best quality parts and take pride in…